Why partitions are the core of most defits
Almost every commercial fitout starts with partitions. Offices, meeting rooms, reception, storage, all defined by walls the tenant put up. Taking them out is the visible part of a defit, and doing it well is the difference between a base building that needs a light make good and one that needs a heavy one.
The partition itself is not the problem. The fixings are. Head tracks screwed to the ceiling grid, floor tracks anchored to the slab, wall ends fixed to the base building walls. Each one leaves a mark.

Partition types
- Plasterboard on steel stud. The standard. Sheeted both sides, often insulated, sometimes running above the ceiling to the slab. Comes out as board, insulation and framing, separately.
- Glass partitions. Framed or frameless, single or double glazed. Glass is handled and removed as panels, framing as aluminium. Both have resale or recycling value.
- Demountable systems. Modular partitions designed to come apart. Fastest to remove and often reusable.
- Full-height walls to slab. Where a partition runs through the ceiling to the structural slab for acoustic or fire reasons, removal opens the ceiling and involves the fire services above.
Ceilings
Most Coast commercial space has a suspended grid ceiling, and most leases treat that grid as base building. So the ceiling usually stays. What comes out is what the tenant added: bulkheads, feature ceilings, dropped sections over reception, and the damage the partitions did to the grid where they were fixed to it.
Where the lease requires a cold shell, the grid comes out too, and that exposes services, fire sprinklers and lighting above it that all need handling.
What is above the ceiling
Ceiling voids hold data cabling, lighting circuits, aircon ducting, sprinkler pipes and sometimes the previous three tenants' abandoned cabling. A partition running to slab or a bulkhead removal opens all of that. Services need identifying and isolating before anything is cut, and abandoned tenant cabling is usually the tenant's to remove.
Protecting the base building
The base building walls, columns, slab and grid are the landlord's. Removal is done so as not to damage them, which means cutting fixings rather than tearing, supporting the grid as head tracks are released, and protecting glazing and floors during demolition. Damage to base building caused during the defit is the tenant's cost, on top of everything else.
Check your lease and the current law before you rely on this
This page describes Queensland commercial lease obligations and defit practice in general terms as they stood in September 2026. The law changes, leases differ, and what applies to you is in your lease.
The statutory position is in the Property Law Act 2023 and, for retail premises, the Retail Shop Leases Act 1994, both at legislation.qld.gov.au. The Queensland Small Business Commissioner publishes a make-good factsheet and offers mediation. Business Queensland covers ending a lease. Building work licensing sits with the Queensland Building and Construction Commission. Where anything here differs from those sources or from your lease, they are right and we are not.
We are not lawyers, property managers or certifiers. For what your lease requires and whether it can be negotiated, get legal advice.
Accurate at the time of writing, September 2026. Always check the source before relying on it.