Home  /  Floor covering removal

Floor covering removal on the Sunshine Coast

Carpet tiles, broadloom, vinyl, timber and tiles, and the adhesive underneath, which is usually the part that decides the price.

The floor is a lease question first

Whether the floor comes up at all depends on the lease. "Remove tenant fitout and make good" often leaves the floor in place, with damage repaired. "Cold shell" or "base building" means back to slab. "Original condition" means whatever the condition report shows, which might be the previous carpet reinstated.

So before quoting the floor, the clause gets read. It is one of the largest single items in a defit and it is the one most often assumed rather than checked.

Lifting the carpet is an afternoon. Getting the adhesive off the slab underneath is where the day goes.
Commercial carpet being lifted in strips from a concrete floor with adhesive residue visible and a floor scraper machine parked at the edge
The adhesive residue is the real job

By covering type

  • Carpet tiles. The easiest. Usually laid on a tackifier that releases cleanly. Lifted, stacked, often recyclable through the manufacturer's take-back scheme.
  • Broadloom carpet. Cut into strips and rolled. Glued-down broadloom leaves adhesive and sometimes underlay bonded to the slab.
  • Vinyl and sheet flooring. Glued down hard. Comes up in strips with a scraper and leaves a full adhesive layer that has to be mechanically removed.
  • Timber and laminate. Floating floors lift easily. Glued or nailed timber does not, and nailed timber over a slab means a battened subfloor that also comes out.
  • Tiles. Removed with a breaker or a tile stripper, then the bed ground back. The heaviest waste and the most dust.
  • Polished concrete overlays and epoxy. Ground off. Slow, dusty, and needs dust extraction on a live building.

Adhesive and the slab

Adhesive removal is mechanical: scraping, then grinding. On a large floor it is done with a ride-on scraper and a planetary grinder with dust extraction. The finish the lease requires matters: "clean slab" means adhesive off and the surface reasonably even, not a polished floor. Over-grinding costs money and can damage the slab.

Older adhesives, particularly black cutback adhesive under vinyl in pre-1990 buildings, can contain asbestos. That is tested before it is disturbed, and if positive, removal is a licensed asbestos job with clearance before other work continues.

Dust, noise and the building

Grinding is the loudest and dustiest part of a defit. In a strata building or a shopping centre it is usually restricted to certain hours, needs dust extraction and containment, and may need notification to neighbouring tenancies. Those constraints belong in the program, not discovered on the day.

Reinstating a floor

Where the lease requires new floor coverings rather than a bare slab, that is a make-good item and it is priced separately: usually carpet tiles to the base building specification, sometimes vinyl in wet areas. Ask the property manager for the building's floor specification before buying anything.

Written September 2026

Check your lease and the current law before you rely on this

This page describes Queensland commercial lease obligations and defit practice in general terms as they stood in September 2026. The law changes, leases differ, and what applies to you is in your lease.

The statutory position is in the Property Law Act 2023 and, for retail premises, the Retail Shop Leases Act 1994, both at legislation.qld.gov.au. The Queensland Small Business Commissioner publishes a make-good factsheet and offers mediation. Business Queensland covers ending a lease. Building work licensing sits with the Queensland Building and Construction Commission. Where anything here differs from those sources or from your lease, they are right and we are not.

We are not lawyers, property managers or certifiers. For what your lease requires and whether it can be negotiated, get legal advice.

Accurate at the time of writing, September 2026. Always check the source before relying on it.

Questions

Common questions

Does the floor have to come up?

Only if the lease says so. Many leases leave floors in place with damage made good. Cold shell or base building means back to slab. Read the clause before assuming.

Why is vinyl more expensive to remove than carpet?

It is glued hard and leaves a full adhesive layer that has to be mechanically ground off the slab. Carpet tiles lift cleanly. The adhesive, not the covering, sets the price.

What is cutback adhesive?

A black bituminous adhesive used under vinyl in older buildings, which can contain asbestos. It is tested before disturbance. If positive, removal is a licensed asbestos job.

How clean does the slab need to be?

To what the lease specifies. Clean slab usually means adhesive off and surface even, not polished. Over-grinding costs money and can damage the slab.

Can grinding be done during business hours?

In a strata building or centre, often not. It is loud and dusty and usually restricted to certain hours with dust extraction and containment. Check the building rules.

Can the carpet tiles be recycled?

Often, through manufacturer take-back schemes. It reduces tipping fees and it is worth asking about.

What if the lease requires new carpet?

Then it is a make-good item priced separately, to the base building specification. Ask the property manager for the spec before buying.

How long does floor removal take?

Carpet tiles in a suite, a day. Glued vinyl or tiles with grinding, several days for the same area. Large retail floors can be a week.

Next step

Send the tenancy and the date

Address, rough size, what is in there, and when the lease ends. That is usually enough for a price without anyone visiting.

Scroll to Top