Home  /  Kitchenette & joinery

Kitchenette and joinery removal on the Sunshine Coast

Cabinets, benches, sinks, reception desks and built-in storage, with the plumbing capped behind them and the walls made good where they were fixed.

Joinery is fitout

Anything built in by the tenant is fitout and comes out under most make-good clauses: the kitchenette, reception desk, wall units, storage cupboards, boardroom credenzas, bathroom vanities the tenant added, shelving systems. What stays is what the landlord provided, which the condition report should show.

Joinery removal is straightforward on its own. It becomes a proper job because of what is behind it: plumbing in a kitchenette, power and data in a reception desk, and the fixings into the wall that leave the make good.

The kitchenette is two hours of joinery and a licensed plumber. Skip the plumber and it is a flood on handover day.
Office kitchenette stripped back with cabinets removed leaving wall outlines, the sink disconnected on the floor and capped copper pipes and waste at the wall
Cabinets out, sink off, pipes capped. Then the wall gets made good

Kitchenettes

  1. Water isolated at the tenancy valve, then hot and cold capped at the wall by a licensed plumber.
  2. Waste capped at the wall or floor, sealed so the tenancy does not smell of the building's drainage.
  3. Dishwasher, zip tap and filtered water disconnected. Boiling water units isolated electrically first.
  4. Sink and benchtop removed, then base and wall cabinets.
  5. Splashback removed if tenant-installed, tiles or glass, and the wall behind made good.
  6. Power outlets for appliances dealt with by the electrician, either removed and blanked or left as base building.

Whether the capped services stay capped or are removed back to the riser depends on the lease and the landlord. Many landlords want them left capped for the next tenant's kitchenette. It has to be agreed.

Reception desks and built-ins

Reception desks usually carry power and data. Wall units are fixed through plasterboard into studs or into masonry. Both leave the make good: fixing holes patched, wall painted, floor made good where the desk sat on a different finish.

Solid timber and stone joinery sometimes has resale value and is worth removing intact rather than demolishing. Worth asking before it gets broken up.

Bathroom vanities

Where a tenant has added or replaced bathroom joinery, the same rules apply: plumber caps or reinstates, joinery comes out, wall made good. Where the vanity was base building, it stays.

Waste

Melamine and MDF joinery is bulky, heavy and mostly not recyclable. Stone benchtops are heavy and go to specialist recycling or landfill. It is a real volume of waste for a small area of tenancy and it is a line on the quote.

Written September 2026

Check your lease and the current law before you rely on this

This page describes Queensland commercial lease obligations and defit practice in general terms as they stood in September 2026. The law changes, leases differ, and what applies to you is in your lease.

The statutory position is in the Property Law Act 2023 and, for retail premises, the Retail Shop Leases Act 1994, both at legislation.qld.gov.au. The Queensland Small Business Commissioner publishes a make-good factsheet and offers mediation. Business Queensland covers ending a lease. Building work licensing sits with the Queensland Building and Construction Commission. Where anything here differs from those sources or from your lease, they are right and we are not.

We are not lawyers, property managers or certifiers. For what your lease requires and whether it can be negotiated, get legal advice.

Accurate at the time of writing, September 2026. Always check the source before relying on it.

Questions

Common questions

Who disconnects the kitchenette plumbing?

A licensed plumber, before the joinery comes out. Water isolated, hot and cold capped, waste sealed. It is a named item on the quote and not a job for the demolition crew.

Do the capped pipes stay?

Depends on the lease and the landlord. Many prefer them left capped for the next tenant's kitchenette. Some require removal back to the riser. Confirm in writing.

Is the splashback tenant fitout?

If the tenant installed it, yes, and it comes out with the wall behind made good. If it was base building, it stays. The condition report should show which.

What about the boiling water tap?

Isolated electrically by the electrician first, then disconnected by the plumber. It is a pressure appliance and should not be pulled live.

Can joinery be sold rather than dumped?

Solid timber and stone joinery sometimes has resale value and is worth removing intact. Melamine and MDF generally does not.

Does the reception desk count?

Yes, if the tenant installed it. It usually carries power and data that need isolating, and it leaves fixing holes and a floor mark that need making good.

What if the bathroom vanity was the tenant's?

Same process: plumber caps or reinstates the original, joinery out, wall made good. If the vanity was base building it stays.

How long does a kitchenette removal take?

Half a day for the joinery plus the plumber and electrician. The make good of the wall behind it adds a day for patching and painting.

Next step

Send the tenancy and the date

Address, rough size, what is in there, and when the lease ends. That is usually enough for a price without anyone visiting.

Scroll to Top